|
Oldest posts shown first (Show Newest First) |
(Print Booklet) |
|
π PT109 ELCO 80ft PT Boat 1:20 3D printed
2 years ago by
π©π° Tica (
Chief Petty Officer 2nd Class)
Flag
Found a set of 3D files on www.cgtrader.com designed by bensworx.
I have printed most of the parts, know and has started to assemble it.
It will be big model Length 4ft and beam 1.05ft the four hull parts took a total of 10 days to print.
Hull is printed in 0.2layers so some sanding and filler is needed to get it where it should be. Other parts has been printed at 0.16 and 0.12 layer thickness. Crew and some other parts that should be smooth and not easy to sand, will be printed on a resin printer.
▲
β©β©
No likes yet
This member will receive 1 point
for every like received
π Started to build again :-)
8 months ago by
π©π° Tica (
Chief Petty Officer 2nd Class)
Flag
Back in business more or less I couldn't sand the hull down in the garage due to other stuff going on there, so had to wait for good weather.
Have to balance this project between my job and another project (not model boat related)
Did managed to get first layer of P100 on 2/3 of the hull and it's now curing in the good weather.
▲
β©β©
No likes yet
This member will receive 1 point
for every like received
π Stand 50cal. and crew
8 months ago by
π©π° Tica (
Chief Petty Officer 2nd Class)
Flag
▲
β©β©
No likes yet
This member will receive 1 point
for every like received
π Gun and engine deck
8 months ago by
π©π° Tica (
Chief Petty Officer 2nd Class)
Flag
▲
β©β©
No likes yet
This member will receive 1 point
for every like received