All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
February 2019: 8 people January 2019: 16 people December 2018: 6 people November 2018: 11 people October 2018: 9 people September 2018: 13 people August 2018: 5 people July 2018: 8 people June 2018: 8 people May 2018: 7 people April 2018: 9 people
Good morning folks, I have a Dremel Workstation, or drill stand as I call it, and would like to get a small machine vice (is that the correct name?) to go with it. I have seen a few smallish ones but they are usually too big to bolt to the base. Can anyone out there offer any workable suggestions please? Also, is the material the vice is made from of make any relevance at this small size, i.e. is cast aluminium any good? ( I had a screw-on table top vice made of cast aluminium which snapped in half the first time I used it.) I feel the need for this vice as I am about to drill a 1mm hole in a model yacht's mast to locate the boom vang and with my shaky hands it could end up being big enough to pass the boom through without some sort of support!!
Hi Chris, do you have a picture of the base it is to be fixed to, with approximate sizes, as I may have what you need in my workshop. You can PM me if you want as I am not too far from you. Cheers Colin.