All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
March 2018: 9 people February 2018: 8 people January 2018: 25 people December 2017: 7 people November 2017: 13 people October 2017: 9 people September 2017: 15 people August 2017: 10 people July 2017: 4 people
OK, I have a problem I've built her and the float test is a failure she has water ingress on her starboard side midships! The hull is made of plastic (ABS) i believe! What can I do to, or put on the hull to keep her from sinking? I used caulking but to no avail. HELP!
Thanks, I've been trying to track it down it's some where midships, I will do how you said and put Epoxy in the seam. in the mean time I've had to glue a strip port to starboard midships and another far and aft along the seams that are exposed! looks ugly but if it helps my boat float i don't care what it looks like! its all under water. I'm trying to help it float because it's a $500.00 boat, and that's the cost without running hardware!
Thanks for the suggestion, I will be ordering some this Friday! The model still has a bit of water ingress but, I must be on the right trail, Because its slowing down. I put glue on the outside seam, next is epoxy on the inside, hum!
Hi Haverlock Really appreciate the recommendation on the pipe weld I'm ordering it a.s.a.p. I was successful in stopping the leak, how ever I'm keeping the hull in a shallow bath to see if there's any water ingress! I've placed 14 Cans of about 15 oz's a piece. into the hull to bring her down to the water line.