All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
February 2019: 10 people January 2019: 16 people December 2018: 6 people November 2018: 11 people October 2018: 9 people September 2018: 13 people August 2018: 5 people July 2018: 8 people June 2018: 8 people May 2018: 7 people April 2018: 7 people
I have installed a Hitec HS-82MG servo for the sails and the HS-81 for the rudder. In all my searching through various sites I can find no verbal with illustrations telling how to attach the kite string (Sheet) from beginning to end.
I know, I need a bowsie for the main sail in there some where too.
The Jib is rigged with a single bowsie with the sheet running through the ring which slides on the rail. The Jib will not be controlled by the servo arm, I am not sure how much torque these small servos can take?
So I need help running the kite string from below deck up to the main sail.
Hi Ron Specs for the HS-82MG are Motor Type: 3 Pole Bearing Type: None Speed (4.8V/6.0V): 0.12 / 0.10 sec @ 60 deg. Torque oz./in. (4.8V/6.0V): 39 / 47 Torque kg./cm. (4.8V/6.0V): 2.8 / 3.4 Size in Inches: 1.17 x 0.47 x 1.16 Size in Millimeters: 29.72 x 11.94 x 29.46 Weight ounces: 0.66 Weight grams: 18.7 It is metal geared but may struggle as a sail winch. A single arm servo usually has an elastic band attached to the other end of the line (kite string) from the servo arm. So you run the line thro the hole in the cockpit coaming and take it to a pulley attached to the deck in line with the hole and near the stern. The line then runs along the deck and near the front of the coaming an elastic band is attached and run to a fixing near the bow. You then use a line with a bowsie to connect the mainsail to the winch line via a fixing on the deck below the boom. There may be other ways to run the line but the important point is to keep the line tight at all time to prevent tangling.