All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
January 2019: 12 people December 2018: 6 people November 2018: 11 people October 2018: 9 people September 2018: 13 people August 2018: 5 people July 2018: 8 people June 2018: 8 people May 2018: 7 people April 2018: 21 people
Traditionally, when powering a Rx from more than one source, such as using a BEC circuit and a separate Rx supply battery, the positive power feed from the ESC is disconnected. This avoids the double power feed. I am embarking on a triple hand screw model with 3 x ESCs so each screw can then be controlled individually from the Rx. In this situation, where all the Rx power will come from ESCs running off the same main battery (using the BECC), with no separate Rx battery supply, is it necessary to cut all the positive ESC supply leads except 1? Appreciate any advice. Thanks Rowen
Yes that is correct you only need power supply from one feed . But I would recommend just removing the + pin from the plugs and taping it up rather than cutting the wires as you never know that they could be used in the future
Former tug nut now switched to sail because of health