All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
December 2018: 4 people November 2018: 11 people October 2018: 9 people September 2018: 13 people August 2018: 5 people July 2018: 8 people June 2018: 8 people May 2018: 7 people April 2018: 24 people March 2018: 11 people
After adding the needed weights to bring this freighter down to a loaded ship water line, the model rocks n rolls. It needs either a keel or exterior stability fins. What is your experience? Please share with us.
you could consider using some of the modern tech and fitting active stabilizers there are a lot of cheap solid state gyros and if your receiver does not have enough free inputs and outputs an arduino mini could handle the logic.
"that's not a bug its just an undocumented creature."
Sir Terence David John "Terry" Pratchett, OBE (28 April 1948 - 12 March 2015)
Think a bilge keel should be the first step. My next suggestion would be to add some of the ballast to a removable fin keel, bolted to the underside of the hull. This will increase the righting moment, but not the weight. This can be seen if you examine U Tube videos of cruise ships and liners. They have so much superstructure they are inherently unstable. Have built several freighters and always fit captive nuts into the keel or underside. These are intended for trunnion display mounts, but have always been prepared to bolt a keel on if needed. The nuts can easily be sealed when sailing.
Hi Ron, had the same problem with my 8'-6'' HMS Fearless when I first launched it. Took out all the ballast, weighed it then replaced it with a solid steel keel on edge bolted to the underside of my boat.... cured and never any more problem since. Fast boats go past it and it sits still with the wake going along side, just like the real one. It gave the boat a stabilising keel and put all the ballast 60 mm lower than being inside the boat. Good luck with yours, interested as to how it turns out.