All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
November 2018: 8 people October 2018: 9 people September 2018: 13 people August 2018: 5 people July 2018: 8 people June 2018: 8 people May 2018: 7 people April 2018: 24 people March 2018: 13 people February 2018: 5 people
If you have access to the drawings, then measure in several places, level on the bench according to your marks and then run a pencil mark around the hull. Then you have a continuous line to align the tape with. Depending on the hull build, you might have to measure down from the deck (My dad added .75" to the depth of hull to gain displacement for batteries etc.) This led me to measure from the deck line. Once model is in the water, shift ballast around until it is level with the line.
Thank you both. Do not have plans or a laser, but I take the point about allowing for the load re batteries ect. Only just starting with filler primer so have a little time yet to get the bits. Cheers all. NPJ
By printing those photos on A4 you can use dividers and a calculator to determine the ratio between the photo scale and your model. You can then use that info to transfer the line location to your model.
Evenin' Neville, yeah, that colour pic will make a good poster in A3👍 But print it on a decent gloss photo paper with minimum 300dpi cos you'll be able to see much more detail than with normal copy paper. Now I'm on tenterhooks waiting for the 'unexpected extra'! We know you and your 'extras' 😲😁 All the best and much success, Cheers, Doug 😎
Young at heart - slightly older in other places 😉 Cheers Doug Grant me the Serenity to accept things I can't change, - the Courage to change things that I can, and the Wisdom to know the difference!