All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
October 2018: 5 people September 2018: 13 people August 2018: 5 people July 2018: 8 people June 2018: 8 people May 2018: 7 people April 2018: 24 people March 2018: 13 people February 2018: 8 people January 2018: 9 people
I have installed a JP EnerG C60 0/R670 (50-20) and am trying to programm the Hawk FS BL100 controller. It asks for how many poles. Does anyone know the number of poles, please? As i cannot get it to work 😡
I have a hawk BL60 and when setting up left it at 2 poles as I couldn’t find the number of poles on the Graupner HPD 2920 4000
And it works ok have fitted to of these in my crash Tender and both worked fine although I find it a bit fast with the 11 volt lipos
Actually 4 pole , "Graupner HPD 2920-4000 High-end brushless motor Particularly suitable for: MiniMono, MiniHydro, MiniCats, MiniHydroplanes, aircraft with wingspan up to 1 m, off-road and on-road 1:12
Features ?Special CNC-machined housing for maximum heat dissipation ?High-efficiency 4-pole 12-slot brushless motor ?High-performance rotor with Kevlar reinforcement ?High-purity copper coils for optimised conductivity ?Extremely strong sintered neodymium magnets ?Intense torque at low weight
Specification Operating voltage range : 4,2-16,8 V No-load speed: 29600 U/min All-up weight, approx. : 90 g Free shaft length: 10 mm Recommended controller: Navy V75 G7257 Output : 650 W Number of poles: 4 Permissible motor direction : R und L Nominal voltage: 7,4 V Case length: 30 mm Shaft diameter: 4 mm Case diameter: 29 mm Revolutions/Volt: 4000 "
Taken from one Google, first response at Cornwall Models Boats!😉 Note. 650W, Nominal voltage 7.4V. No wonder it's a bit quick on 11.1V 😲 Cheers, Doug 😎
Young at heart - slightly older in other places 😉 Cheers Doug Grant me the Serenity to accept things I can't change, - the Courage to change things that I can, and the Wisdom to know the difference!
Thanks again been searching all over for that info. Got my Crash Tender completed just setting up the the smaller 7.4volt lipo’s if ok will show the photos. Did find with the Hawk escs set up the forward stop and reverse settings as per the instructions and the motors worked immediately only had to go into the parameters to set the reverse. So you may have another problem on your setup and not the hawk esc