All donations are securely managed through PayPal. Amounts donated are not published online.
Many thanks for your kind support.
Model Boats Website Team
December 2017: 4 people November 2017: 13 people October 2017: 9 people September 2017: 15 people August 2017: 10 people July 2017: 16 people June 2017: 8 people May 2017: 8 people April 2017: 17 people
Hi Andy, depends which type you have. The 300 series just have bronze and brass bushes as bearings. These will need lubricating! The data sheet (see attached) says ensure components are well greased! The 301 series have bronze and Delrin self lubricating bearings and the data sheet (see attached) says lubrication is unnecessary! All info and data downloads are here http://raboeschmodels.com/index.php/en/component/virtuemart/... Cheers Doug 😎
Attached Files - Click To View Large
Young at heart - slightly older in other places 😉 cheers Doug
I'm reading the chat about stuffing boxes & shafts lots of guys in the club I'm in drill a hole into the stuffing box & solder a small tube over the hole to add oil or grease into the box . I goofed when I built my Sea Commander as I had no stuffing box but I had a shaft so I just used a brass tube for the shaft & lubricated the shaft with Sil-Glyde Lubricating compound a Silicone based grease I also use rudder O-Rings to help stop water getting into model through stuffing box. Kind of Mickey Mouse but it works .Except on first run out of water it does squeal a little but in the water it's fine.