On the cabin roof is the radio aerial, the kit supplies a base in white metal, but to accommodate my aerial design I decided to machine my own out of brass. I wanted the pole to be tapered and with it being only 2mm dia I found the easiest way was to support the piece in a wooden block at the same height as the Dremel laid flat on the bench. With the piece rotating, I used a smooth file and grades of wet & dry to taper down to 0.75 dia. Next I machined the 2mm end down to 1.5mm to accept the spring, this spring will be soldered to a lower piece which then goes through the base and into the cabin where itโs bolted in position. I decided to incorporate a spring to make sure it does not get accidently bent.
Soft soldering was chosen, as the silver solder would have tempered the spring. The result was really better than I could have imagined.
Loud Hailer
Another heavy item, first job hollow out with the Dremel and then fill with polystyrene and top with
Milliput
and sculpt the shape โresult, the weight was halved. Next I made a frame in the same way as the one I did for the search light โ (see search light)
All the cabin furniture has to be mounted on the roof which is curved! I found the best way was to use
Milliput
. The method was as follows,
1 Drill the hole for each item in the appropriate place
2 Make sure the fastening method for each piece will hold the piece upright (I tapped the hole 8BA)
3 Make a dividing piece from PTFE baking sheet circular for most items but oblong for the mast feet
4 Roughen the surface where the items contact the cabin roof
5 Place the divider on the items base
6 Mix a small amount of
Milliput
7 Place a circular amount under each item
8 put some Vaseline on the securing bolt so it doesnโt stick
9 Pull the item down to the desired height and fasten in position then trim around the bases
10 When dry remove the item and the baking sheet, paint as required
11 sorry if this is common knowledge