π rc equipment help!!!
3 months ago by
π¬π§ Brocker (

Recruit)
Flag
Hi,
Not sure why you need the voltage reducer, the ESC will output 5v to run the receiver and servos.
The motor can connect in any order to the esc wires, if it runs in wrong direction just swap two of the wires over, unless your esc is programmable and you have programmer to reverse it.
Good luck.
▲
β©β©
No likes yet
This member will receive 1 point
for every like received
π Wanted: accesories
3 months ago by
π¬π§ Brocker (

Recruit)
Flag
Hi Julio,
I 3D print a lot of things including boats, and have an Aeronaut Classic, but I wouldnβt use 3D printed parts on the exterior, for such a class ice boat like a Riva you need metal parts to make it look correct. The suggested companies are mostly ones I would recommend too, also check Aeronaut out.
Good luck
Neil
▲
β©β©
No likes yet
This member will receive 1 point
for every like received
π Aeronaut's Yacht Bella
5 months ago by
π¬π§ Brocker (

Recruit)
Flag
Hi,
Sussex models has one for Β£189 which is about Β£9 more than what Hobbies sold it for when in stock, and they are normally reasonably priced. Alternatively build the smaller version Bellissima.
Good luck!
▲
β©β©
No likes yet
This member will receive 1 point
for every like received
π¬ Re: M-Jet boat 3D printed
11 months ago by
π¬π§ Brocker (

Recruit)
Flag
Iβve printed one of these Iβm running a 3660 2850kv on 4s itβs crazy fast!
Hope your enjoying as much as I am, the green looks greatπ
▲
β©β©
No likes yet
This member will receive 1 point
for every like received