I'm not sure how this will work.
Three D printing forms used will fiberglass.
My thinking is using the same way of construction that I used with My Thames Barge Col
[{"id":"17892993887","name":"17892993887.jpg","caption":"","url":"https:\/\/model-boats.com\/media\/17892993887\/l","thumbUrl":"https:\/\/model-boats.com\/media\/17892993887\/s","isImage":true,"ext":"jpg"}]
I'm not sure how this will work.
Three D printing forms used will fiberglass.
My thinking is using the same way of construction that I used with My Thames Barge Col
This puffer project is a tad on the experimental side, it may work then yet again there is a chance it wont Col
[{"id":"17894797671","name":"17894797671.jpg","caption":"","url":"https:\/\/model-boats.com\/media\/17894797671\/l","thumbUrl":"https:\/\/model-boats.com\/media\/17894797671\/s","isImage":true,"ext":"jpg"}]
Alessandro I used the same method (not 100% the same) that I'm thinking of for my Thames Barge, the choice of materials so much different today , 3D printing , foam spray, than I had all those years ago ,anyway as I say only time will tell Col
So, it's on the back burner as the old saying goes.
While I can get my head around mixing the formats.
In the meantime, I will devote my energy into the first puffer Col
So, it's on the back burner as the old saying goes.
While I can get my head around mixing the formats.
In the meantime, I will devote my energy into the first puffer Col
The project started as a larger Clyde Puffer than the Mk I model.
As I say tis is the classic ColRay 110% turnabout.
One: I will not be using any file for 3D printing found on the internet.
Two: Design the profile for blueprints/plans * using a CAD program
Three: Maybe construct a maquette, or go straight in at the deep end.
Four: If it doesn't work find another hobby , just kidding
Col
Just another Thought.
I have a good sailing spot right on my doorstep, just one problem I will be all myself.
Just 10ks away in one of the parks is a very nice boating lake run by the City of Albany , away from the strong winds down on the harbour custom made for model boat, just one slight hitch sailing boats only so my new venture will be just fine.
*Looking hi 'n lo for anything that could work
The project started as a larger Clyde Puffer than the Mk I model.
As I say tis is the classic ColRay 110% turnabout.
One: I will not be using any file for 3D printing found on the internet.
Two: Design the profile for blueprints/plans * using a CAD program
Three: Maybe construct a maquette, or go straight in at the deep end.
Four: If it doesn't work find another hobby , just kidding
Col
Just another Thought.
I have a good sailing spot right on my doorstep, just one problem I will be all myself.
Just 10ks away in one of the parks is a very nice boating lake run by the City of Albany , away from the strong winds down on the harbour custom made for model boat, just one slight hitch sailing boats only so my new venture will be just fine.
*Looking hi 'n lo for anything that could work
