This is my Billings USCG Life boat. Had not installed esc into the finished boat. Had a P94 duel esc operation and P92 power destitution board Component Shop (Action Electronics)units taken from another build shelved as it became to big a job at the time. May finish one day.
The boat has twin props and rudders so with the P 94 unit can run the boat now. Boat is now ready for water tests.
Rick
[{"id":"161944347491","name":"161944347491","caption":"","url":"https:\/\/model-boats.com\/media\/161944347491\/l","thumbUrl":"https:\/\/model-boats.com\/media\/161944347491\/s","isImage":false,"ext":"file"},{"id":"161944352942","name":"161944352942","caption":"","url":"https:\/\/model-boats.com\/media\/161944352942\/l","thumbUrl":"https:\/\/model-boats.com\/media\/161944352942\/s","isImage":false,"ext":"file"},{"id":"161944357964","name":"161944357964","caption":"","url":"https:\/\/model-boats.com\/media\/161944357964\/l","thumbUrl":"https:\/\/model-boats.com\/media\/161944357964\/s","isImage":false,"ext":"file"},{"id":"161944363669","name":"161944363669","caption":"","url":"https:\/\/model-boats.com\/media\/161944363669\/l","thumbUrl":"https:\/\/model-boats.com\/media\/161944363669\/s","isImage":false,"ext":"file"},{"id":"161944368722","name":"161944368722","caption":"","url":"https:\/\/model-boats.com\/media\/161944368722\/l","thumbUrl":"https:\/\/model-boats.com\/media\/161944368722\/s","isImage":false,"ext":"file"}]
This is my Billings USCG Life boat. Had not installed esc into the finished boat. Had a P94 duel esc operation and P92 power destitution board Component Shop (Action Electronics)units taken from another build shelved as it became to big a job at the time. May finish one day.
The boat has twin props and rudders so with the P 94 unit can run the boat now. Boat is now ready for water tests.
Rick
Congratulations, Rear Admiral Rick, it sounds rather well and suits you, and is well deserved on your part. Do I get an invite to the party or what? Regards, Gary.
The P92 unit was set up with direct battery hookup.With the system working found a switch to use cut a hole in the deck to mount and cut wiring to suit.Test the units again after switch install.Power to the P 92 was right but only one motor worked found a loose wire on the motor fixed that.Tested again a wire came off on the other motor.Took out both motors and put on new wires.Setup complete .
Rick
The P92 unit was set up with direct battery hookup.With the system working found a switch to use cut a hole in the deck to mount and cut wiring to suit.Test the units again after switch install.Power to the P 92 was right but only one motor worked found a loose wire on the motor fixed that.Tested again a wire came off on the other motor.Took out both motors and put on new wires.Setup complete .
Rick
Rick