HI Fellow Enthusiasts
These pictures show my scratch built RAF Air Sea Rescue launch 2507. it was built using my own scaled up planes over the period July 2006 to August 2008. its approx. 4 feet long by 11 inch wide and stands 24 inch high.
The boat has twin Johnson brushed electric drives via 2.5/1 reduction gearboxes with three bladed 40 mm brass props. The speed controllers being 15 amp Electronize supplied from 4.5 amp D cells made into a 12 volt battery pack.
The boat sound system consists of a Diesel sound generator and machine guns being fired by an electronic ring counter circuit that allows the guns to fire individually or together depending on their selection via a diode network. The unit is switched on and off via a Electonize switch unit that also switches the boats lighting system on and off.
All the special fixtures required for this model being self made this includes the figures found on and in the boat. The basic figures are usually obtained from car boot sales or the local ÂA£ shop for next to nothing and then modified to the model boats requirements.
Launch 2507 was commanded by F/O W. Garret who reputedly made the most northerly pick up on the 26th June 1944 for the crew of a downed Catalina, for this action he was awarded a M.B.E. The Catalina pilot F/Lt. Horner R.C.A.F. died of exposure and was awarded a posthumous V.C.
I hope you enjoyed the pics and information.
Regards
GreyWolf

Svitzer tug Ayton Cross, built by Terry O'Rourke in 2006/2007. Mostly scratch built, on a Mobile Marine Models GRP hull.

She is powered by two car heater motors, with a Marx luder bow thruster. I have used an Action kit motor mixer, it works well.

These photos were taken at the Chantry club lake, at the Bluewater shopping centre in kent.

This is the Brackengarth, it is semI scratch on mobile marine models grp hull. Built 2005.

It's powered by a car heater motor plus bow thruster. it is sailed with Chantry Club on lake at Bluewater shopping complex in Kent.

This model is a British "Hunt" Class destroyer.

It is a Sirmar limited edition (100) semI kit at 1/48 scale and some 6 feet in length. When he bought the model it was already constructed, but as a static model. So out came the jigsaw, Manual NOT powered.

The deck around the aft gun turret was cut to allow a good inspection of the inside of the hull. He tried to remove the bridge superstructure but this would have meant destroying it to remove. Out came the jigsaw again and cut an access hatch in the main deck.

The steering servo was fitted and attached ( by keyhole surgery ) and 2 x MFA 800 motors were fitted. Scale Prop Shop Props were fitted and the radio gear just jury rigged for her first trial. She was roughly ballasted with 2 x 12volt 7Ah batteries and she was ready for her first trials.

She sailed well with no water ingress to the hull, so the radio gear was installed properly with individual speed controllers to each motor. The results are as seen here.

This is an original 46 inch Aerokits Crash Tender from c1966. it was restored by Mike Cummings who runs the Vintage Model Workshop group.

It is powered by a Graupner Speed 900 running on 18V. This picture was taken in Bushy Park, SW London.