Comments

Sign in to comment.

1. jumpugly🇺🇸Gold

   Fleet Admiral·27 minutes ago

   Go BOB GO!!!!!!
   This looks like a blast!!!!!!
   😀
2. zooma🇬🇧Bronze

   Admiral·57 minutes ago

   The new blended chine stringers smartened up the underside of the hull - and encouraged me to cut some triangular strips out of obechie to use as strakes.
   
   The number of strakes was decided and their positions marked on the underside before the paint was scraped off in lines wide enough to fit and glue them on.
   
   Once prepped, the strakes were positioned and glued to the hull bottom.
   
   A new rudder and water scoop were fitted to complete the underside up-grade.
   
   Bob.

   Liked by ianpat and jumpugly See all
3. zooma🇬🇧Bronze

   Admiral·1 hour ago

   The underside was the next area to gain some attention with a new prop supporting “skeg” made to support the prop-shaft (and look better!),
   
   The chine stringers had a blunt end. At first I just tried to sand them to make them look better, but then I decided to refinish them to look nicer and blend-in better.
   
   Bob.

   Liked by jumpugly
4. zooma🇬🇧Bronze

   Admiral·1 hour ago

   I guessed what size of motor to use…..and I happened to have this one available. Job done!
   
   A new motor mounting platform with supports was cut and fitted into the hull to correctly align the new motor and shaft.
   
   The water-cooled alloy motor mount was fitted with a new M5 Maxi Shaft prop-shaft and a Maxi Coupling to give the best available drive train.
   
   Bob.

   Liked by jumpugly and EdW See all
5. zooma🇬🇧Bronze

   Admiral·1 hour ago

   These pictures of an original plan and a kit box were provided to the Classic Model Power Boat blog on this site.
   
   Both make a very interesting reference as I had neither with this Wave Rider when I bought it.
   
   Bob.

   Liked by jumpugly and EdW See all
6. zooma🇬🇧Bronze

   Admiral·1 hour ago

   The Wave Rider came with a stand that fitted the hull quite well, but was probably as old as the boat and I wanted to make a new one that had a base on it to make it more sturdy and able to hold any parts as I restore it , and later to carry any oddments to the lake.
   
   An old brushed motor was connected to an equally old prop-shaft that showed some signs of wear and had a wiper board speed controller.
   
   Ann intersting vintage stuff, but I wanted to refresh everything, so they were al removed to give a clean start to the refurb.
   
   Bob.

   Liked by ianpat and jumpugly and 1 other