๐ Help me please
5 years ago by
๐ฌ๐ง m02is500 (
Recruit)
Flag
yes I have a charger the radio set is what I use for my nitro helicopter but thought I would have to go 2.4 ghz the motor is a Johnson 600 3v-12v DC
Operating specifications:
4.8V - 1.4A - 9200 RPM
6V - 1.5A - 11,500 RPM
7.2V - 1.7A - 13,800 RPM
9V - 1.9A - 17250 RPM
12V - 2.3A - 23,000 RPM
the motor is capable of high torque output but the current can easily exceed 40A-50A under load and could hit 80A if stalled at 12V.Ensure that stall situations are prevented by using either a fuse or current limiter in series with the motor.
what would be good is what you need is this speed controller this for the leds ect but I will get there in the end
PS THANK YOU FOR YOUR TIME
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Help me please
5 years ago by
๐ฌ๐ง m02is500 (
Recruit)
Flag
They say a good quality low drain motor such as a Decaperm or Mabuchi 545 or 550 with a reduction gear unit and it said a 3 prop
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Help me please
5 years ago by
๐ฌ๐ง m02is500 (
Recruit)
Flag
I have an old 35mhz but if I need new will get motor is the one that comes with it which is a brushed motor going through a pulley system and the prop was one that came with its well
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Help me please
5 years ago by
๐ฌ๐ง m02is500 (
Recruit)
Flag
I have got a model kit my father never built wich I am now building its a model slipway Maggie M what I need help in is what equipment do I need to put in it eg speed controller and if I want to put leds on it what control board
Thank you for any help
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received