last pictures l posted l painted the wave princess l changed my mind and decided to go for some planking on the decks and cabin roofs l have also done a little bit of tarting up using some brass welding rod and brass tube l am quite pleased with the out come so far. these piccys are about a month old now so she has had a god rub down and given six coats of clear varnish. l will post more piccys when l have installed the windows and frames.

all these boats are scratch built only thing purchased was brass tube for mounting on a base, all these would have made up workboats on board Nelsons ship HMS Victory.
from left to right yawl, cutter, longboat, pinnace, admiral barge

https://model-boats.com/media/np/s/200/1505992838https://model-boats.com/media/np/s/200/15059928https://model-boats.com/media/np/s/200/150599290374

Greetings from Hollywood, California. 😎 Many thanks to David Metcalf at Metcalf Moldings for his advice and for so graciously replacing parts I messed up. This craft has been swimming pool tested (after all we're in Hollywood) and it ran beautifully. Next stop is the local pond. I chose brass counter-rotating props. Those are lithium batteries tucked under the sides. I chose to recut the decks out of wood. Brits rave about plastic but I found it difficult to cut and forget about sanding down the edges. (I guess if you cut it properly you don't need to sand the edge.) Major mistake: watching a You Tube video that told me I should make brass joints using a Propane torch. it will make a good joint but it MELTS ALL THE OTHERS. There was a lot of learning here for me and thanks to David's fine kit I think I'm somewhat of a better model builder.