๐ RAF Fitter 94A
12 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
In response to an enquirey Here is my Fire Boat the right way up!
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ RAF Fitters 94
12 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
In reply to an enquirey here is a picture of my boat at speed
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ฌ Fireboat & Suction (pick-up) Hoses
12 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
I don't have a video but will post a picture when I can remember how! it won't turn well at full speed as it rolls a bit & the outside prop cavitates. Still it's OK if I slow dorn a bit.
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ฌ Fireboat & Suction (pick-up) Hoses
12 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
Hi,
The mast is scratch built from 1mm alloy sheet & a few sizes of oaaly tube, the fittings set came from Model Slipway:
http://www.modelslipway.com/ |
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Fireboat & Suction (pick-up) Hoses
15 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Water pick up hoses
15 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
Many thanks for all the advice, I have some heatshrink to hand and have made a trial inch! more springs are on their way.
Paul
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Water pick up hoses
15 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
I have noticed nice ribbed hoses on several boats on this site. Before I try to make some with cable & heat shrink tubing does anyone know of a source for the hose?
My 34" boat Is coming on well, I hope to have It finished for a show In 3 weeks time!
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ Motor setup for 34" Fireboat
15 years ago by
๐ฌ๐ง raffitter (
Able Seaman)
Flag
I built an Areokits 46" Fireboat In 1967 which I parted with In the 70's. I have decided to re-capture my youth! and build another, and have ordered a Kingston Mouldings hull & plan, this time In the 1/16 scale / 34" size.
Can anyone suggest a suitable power train (motors, ESC, props, etc.) for the size of boat? I guess I would like twin screws and a reasonable turn of speed but not at any cost! ๐ค
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received