๐ prop shaft
11 years ago by
๐ฌ๐ง grandaddave11 (
Recruit)
Flag
yep thanks thought as much,ill shim out with more,brass washers,would you put another nut against prop to lock prop to shaft?
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ prop shaft
11 years ago by
๐ฌ๐ง grandaddave11 (
Recruit)
Flag
hI just received my prop shaft,filled It with grease,there seems to be about 3mm off end float when nuts&washers are fully tigtened,is this the norm?what keeps the water back Is It air pressure being at a angle.
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ฌ flowerdown corvette
11 years ago by
๐ฌ๐ง grandaddave11 (
Recruit)
Flag
doe s it matter on prop handing? or is it a case of wiring motor other way.
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ฌ flowerdown corvette
11 years ago by
๐ฌ๐ง grandaddave11 (
Recruit)
Flag
hI what is the full spec on the motor
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ speed controller
11 years ago by
๐ฌ๐ง grandaddave11 (
Recruit)
Flag
hI can any one recomend a speed controller for futaba 2dr setup? like where to get one struggling. ๐
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received
๐ฌ flowerdown corvette
11 years ago by
๐ฌ๐ง grandaddave11 (
Recruit)
Flag
gathering parts together to start mine,just got rc from ebay need speed controller/batt/prop shaft/prop, what dia props on yours.[newbie]
▲
โฉโฉ
No likes yet
This member will receive 1 point
for every like received