HARTLEY FLARELINE, NEW PROJECT FIRST TEST
Weather was perfect tonight for a test, so I did the 15km trip out to the Gulf harbour pond (most weed free pond) to throw the boat in. After a thorough under water hull inspection from the marine department, she was off. Everything worked ok except the silicone drive tube which had become enlarged due to soaking in the grease coming out the front of the jet shaft. It was slipping badly and probably losing about 60% of its' thrust. Manoeuvrability is excellent but reverse leaves a bit to be be desired. Steering in reverse is perfect but the thrust is not going forwards enough from the bucket. Might have to build in some nozzles to direct it better.
Smoke air and water are working as well as can be expected, (smoke is a bit wafty, but with too much air introduced it will disappear as it gets thinned out too much to see) I was not expecting miracles as this was a bit of an experiment (modified cheap jet unit with unknown abilities) but at least it shows promise😁. If I can find a coupling which is concentric it will solve the drive problem.
Trouble is, the Chinese insist on making a 4mm shaft, 4.95 (or whatever) which is useless for balance in a 4mm ID bearing for example. Fine for cars, but no good for boats or planes due to balance requirements (it's a mission trying to balance plane props due to this thinking,- they do it with everything) shafts for electric motors are a nightmare at times as the play they build in, can ruin an otherwise good motor. I might have to buy a flexible rubber/nylon universal or a collet style( preferable as these take up any undersize on shafts) to fix it. They included a spiral alloy one with the jet unit which is as loose as a rooster in a sock, and only good for slower things like 3D printers etc. One of these days they will learn how to machine things to fit.😐
Smoke air and water are working as well as can be expected, (smoke is a bit wafty, but with too much air introduced it will disappear as it gets thinned out too much to see) I was not expecting miracles as this was a bit of an experiment (modified cheap jet unit with unknown abilities) but at least it shows promise😁. If I can find a coupling which is concentric it will solve the drive problem.
Trouble is, the Chinese insist on making a 4mm shaft, 4.95 (or whatever) which is useless for balance in a 4mm ID bearing for example. Fine for cars, but no good for boats or planes due to balance requirements (it's a mission trying to balance plane props due to this thinking,- they do it with everything) shafts for electric motors are a nightmare at times as the play they build in, can ruin an otherwise good motor. I might have to buy a flexible rubber/nylon universal or a collet style( preferable as these take up any undersize on shafts) to fix it. They included a spiral alloy one with the jet unit which is as loose as a rooster in a sock, and only good for slower things like 3D printers etc. One of these days they will learn how to machine things to fit.😐
Liked by MouldBuilder and Puddle-pirate and
Nice to see her in the water.
I am very surprised at the lack of reverse.
Martin555.
Motor should be spinning at 15,000 rpm with a 3 cell, but performance is not matching that, obviously,- just piddling along😁 Mind you, I used to cruise like that in the full sized boat, as the Zodiac motor used to suck gas like nothing at 20 knots plus, (gallons per mile, not miles per gallon!)
JB