Police (Scotland) 1.12 scale. made from a Semi-Kit by Models by Design, built 2014.
This is modelled from the interceptor42 range by Safehaven Marine. This is my first full build of a model, having only done restorations previously.
Model length is some 42 inch, beam of 12 inch. (106cm x 31cm)
Power is by twin E-Max BL2826 Brushless motors and 1, 80amp speed controller running on 2 NiMH 7.2 volts.
Fitted with Action electronics Police siren, and with detailed rotating blue lights and searchlights.
I sail this at Cold Knap Lake Barry Vale of Glamorgan, and I am the Founding member of the Vale Of Glamorgan Model Boat Club.
Also included is my Portland Pilot interceptor 42 which was the original prototype from Models by Design which I purchased and added lighting etc, this runs on Brushless motor running on 12Volt lead acid.
Visit our website at http://vgmbc.org/

Following burning out the motor by fouling the prop on a polythene bread wrapper I fitted a new 160 amp speed controller and got a bargain motor from Giant Shark. it is an Emax GT4020 which cost about £14. I realised what a bargain it was and went back only to find Giant Shark have ceased trading. The video shows the boat running on a 4 cell Lipo, it goes a bit quicker on a 5 cell that I have. I am really sold on Lipo power as Dave said I would be. I have just ordered a 3 cell Lipo for my crash tender

Designer: Vic Smeed

A 1:12 scale model of a Thorneycroft RAF launch, length 43in., beam 12.5in Suitable for 2.5cc upwards. Excellent for R/C. Completely detailed on two large sheets.
Myhobbystore uk. MM412

I built this Range Safty Launch two years ago and I am now changing the hull paintwork to also include a water line. I never got around to doing this for some reason.

Range Saftey Launch

I purchased the plans for this model after my late father passed away, he too was building this model but failed to finish it before he died. My father was an Ex RAF Patrol boat pilot, hence the design was appropriate. The plans (Two sheets) are really well presented and easy to use. Each of the sheets provide ample detail to construct the basic model and if you are an experienced builder then these should suffice. However, a little research may be required to put the final touches together for the completed model (If you are a perfectionist like me). These plans are suitable for a novice as a first time project. This being my first attempt at a scale model. The boat once completed sails really well. I fitted mine out with electric motors, speed controller etc and when on the water a few heads turned! Fantastic plans GO FOR IT! Roy McCluskey

This is a Kitshack 46 inch Crash Tender. Nearly finished with a bit more detail yet to finish powered by 2 1400 kv brushless motors running on car speed controllers at 7.2 volt. Goes like stink! Has working rotatable fire monitors which are scratch built

here are my three boats, oakgarth 42" twin screw 4 blade props with kort nozzles she also has a working bow thruster.She running two speed controllers off a 12volt sla battery and has full working lights I would love to say I built her but I never, all I have done is added lights and give her a full makeover. Next is Doug the26" pusher tug twin screw 3 blade props full working lights and water jet single speed controller futaba radio set up I have just changed the crane on this again I have only done cosmetics to this tug and my last boat is a 20" seaport tug this is what my grandchildren sail and for 60 quid its great thay love it .the paddling pool was 15 quid for argos and perfect for testing well better than filling the bath .

A Graupner kit built some years ago, was given to me 2013 and I have refurbished the boat to get it sailing again! it has a Mono- perm motor and I have fitted 10 amp Mtronics speed controller and running on 8x AA 1600m/a Nicd batteries wired in parallel.

Built from a Traplet plan 2012, all wood construction with plank- on-frame hull. 385 direct drive motor with 3 blade prop, Mtronics 10amp speed controller and 8x AA 1600m/a batteries wired in parallel.

Built from a Traplet plan in 2013. All wood construction, JP 400 direct drive motor with 2 blade prop. 2x 3.7amp 7.2 volt NiMhd batteries wire in parallel and a Mtronics marine 15amp speed controller.

My own design deep "V" hull with upper-works loosely to 1:15 scale replica of the Mitchell 31 boats previously used by various Hampshire constabularies in and around the Solent. The intention is to fit this model with a working, rotating, radar scanner using the servo motor and gearbox from an old video camera lens system; working lights including flashing blue police lights and a sound-alike "wee-wah" siren - just for the hell of it (and because I can)! Technical details: Hull length: 867mm. Construction: GRP layup with 1.5 and 3mm ply and balsa deck, cabin etc. Motor: MFA Torpedo 850. Propeller: X50mm plastic. Battery: 2 x three cell LiPo pack in parallel. Speed controller: Mtroniks Viper 25Amp. Radio: Hobby King 2.4GHz.

at last I took it for its first run on the lake and it went like a dream,can't tell you how good it looked lots of interest from others,its running on twin Emax EL4030/10 motors,two Hobbywing 60 brushless speed controllers and four 18.5 volt 5s1p LI polymer 4000 mah 35c batteries .what can I say but a really good kit from speed line models,would love to build the trent now but don't think the wife would let me go missing for another year in the shed but fingers crossed

HI All,
Thought you might like to see some pics of my RTTL. 35" long and built from the Vic Smeed plan. She is powered by 2 belt driven 480 motors with 2 speed controllers and 2 7.2 NiMH batteries. Based on the boat stationed in the Maldives in the 1960's.
Dave.

this is the Maggie B she is a modified Sothampton R T R tug. there is a video of her in the video section. the main casing was taken off and the lower three quarters of it was cut off, so that it reduced the overall height., she is fitted with two M tronic speed controllers and a new larger5,000millI amp battery which is fitted across the hull behind the motors and in front of the steering servo, she still has the original props but they are now turnig outwards to go ahead. she is now a very handy and stable boat.